Sparco Evo seat

After buying the set months ago I finally got around to getting the time to fit it. 

I looked on the web and there is a lot of electronics in the original seats so by removing the drivers seat, I had to instal a 3 OHM resistor into the gap in the wiring loom for the airbag system. This is so that once you turn on the ignition the airbag system does not have a break in the circuit and the light will go out after the self check is complete. 

It was pretty straight forward removing the drivers seat, just the four sub frame bolts and then drag it into the garage so I could remove various bolts from it so that I could fit the Sparco seat to the Buddy Club sub frame.

It's easier to bolt the sub frame into the car, then put the seat in place to get a rough measurement of how to adjust the side mount brackets for your height/leg distance, then remove the seat and fit the sub frames. Finally bolt the whole lot back in place in the car.