![[ProjectSTi]](https://blogger.googleusercontent.com/img/a/AVvXsEgqVanZg9w-c4hS30-vwmY1vqbhTqkAlpb0a2RMSq9lGDlNvjWa6PF_M3Dcb_y6Lzef4wChPlx3cJivdW2n8v3tjZ8PrUJzH4D7Ktx4Jhzz0H0hrUmEXP80ofkZt9y5xM1irMQWm787FTXxzia9UsFrNI3MwfiwgLlTpAO-55uip-USRGdOW4WYicZieO0=s174)
I managed to start fitting the kit finally, but so far I only managed to install the bottle brackets in the boot, to hold the bottle.
I had planned on installing the bottle where the back seats where, but this is just above the fuel tank, so no chance to drill there!
I removed the boot lining and managed to get under the car near the exhaust back box and remove the heat shielding. This allowed me to drill through, and tap 4 holes for the brackets. I was then able to fit the brackets and reinstall the shielding from below.
Ill not keep the bottle in place, during road use, as its a little too close to the back bumper....just in case!
I had planned on installing the bottle where the back seats where, but this is just above the fuel tank, so no chance to drill there!
I removed the boot lining and managed to get under the car near the exhaust back box and remove the heat shielding. This allowed me to drill through, and tap 4 holes for the brackets. I was then able to fit the brackets and reinstall the shielding from below.
Ill not keep the bottle in place, during road use, as its a little too close to the back bumper....just in case!
Comments
Post a Comment