Odds and ends

I managed to get a couple of hours this morning to tidy up all the loose ends after the transmission job and and I also wanted to get the car off the axle stands and actually test it. I cable ties up some sensor wires and fed the Nitrous cable back into the boot. Then after one final check I started her up and had a last leaks check. After all was warmed up  I took her fornanspin down the stree to make sure there were no dodgy sounds out of the diff and driveshaft coupling. Once all was good, I then gave it a final blast right up first gear to make sure there was no knocking or noise at high rpm. 

I also found one matching switch in my tool box so I installed the dead man switch as an arming switch for the nitrous as well which I think really finishes it of!