Mapping

So I finally go round to adding a little more boost to the car and its finally starting to feel like it has some serious torque in her!

I did around 4-5 runs flat out at full throttle with data logging to then help me adjust the data for the next run. After a lot of fun, the car really started to come alive. I added boost and fuel until I hit the safety limit, then pulled it back a little to a safe boost setting of 1.25 BAR.

Im going to make some more changes and hopefully get a run tomorrow to bring it up to 1.3/1.4 bar before the dyno run at the weekend.

I went to move the car in the driveway this evening and found some errors on the oxygen sensor so I'll have to jack the car up in the morning so that I can remove the oxygen sensor so that it can be calibrated in fresh air, then re-installed in the decat pipe. Pain in the ass, but I nee to be sure the readings are accurate....otherwise the engine goes lean and BOOM.

Its really becoming LOUD and once your on boost, you just sit in the seat and hold on as the car pins you into your seat. I'm eagerly awaiting that power run.....